2: Installation
PRC1099A-MSOP 2-9
Base Installations
All of the mobile installations described in the previous section can be used as
base stations. In these cases, external power must be obtained from AC power
sources instead of vehicular supplies.
100W
Systems
The 100W systems use UPF7000A-12 (for 12V operation) or UPF7000A-28
(for 28V operation) as the primary power source.
Referring to Figure 2-4, cable C991580 between the vehicular power source
and the MT-1099A is replaced with cable C991614. This cable connects the
MT-1099A to the UPF7000A (12 or 28V).
400W
Systems
The 400W systems use UPS500 and cable C991614 to power the MT-1099A
and the UPS500 power supply as the primary power source for the RA400-99.
Referring to Figure 2-5, cable C991580 between the vehicular power source
and the MT-1099A is replaced with cable C991614; this cable connects the
MT-1099A to the UPF7000A (or RA400-99 DC out). Cable C991558 between
the vehicular power source and the RA400-99 is replaced with cable C991508;
this cable connects the RA400-99 to the UPS500.
Cable Description
C991505 RA400-99 to RAT1000C, RF cable
C991552 RA400-99 to RAT1000C, control cable
C991558 External 24 Vdc to RA400-99, power cable
C991580 External DC power to MT-1099A, power cable
C991614 UPS500 to MT-1099A, power cable
C991620 RAT1000C to RA-MAS, RF cable
C991645 PRC1099A to RA400-99, RF cable
C991949 PRC1099A to MT-1099A, power cable
C992003 MT-1099A to RA400-99, control cable
To Next Page
Loading...
