4: Radio Programming
PRC1099A-MSOP 4-9
Menu
Selections
The following table describes each of the selections within the SCAN menu.
Selection Description
SCAN SEL Scan Select. Enables the channel scanning feature. Once
enabled, the radio begins to scan the channels whenever
the channel select knob is tuned to channel 9. Enter the
channels to scan using SG NUM and MOD SG selections.
SG NUM Scan Group Number. For selecting the group of channels
to scan. A maximum of ten scan groups can be retained in
memory, 00 through 29.
MOD SG Modify Scan Group. For entering or modifying a scan
group. All channels in the radio (00 through 99) display
one at a time. Those channels already in the scan group
have an asterisk (*) next to the channel number. Press the
WHIP TUNE button to select or deselect a channel for the
scan group.
SCAN RAT Scan Rate. For selecting the length of time the radio
remains at each scanning channel during the scan cycle.
Amount of time is selectable from 0.5 to 64.9 seconds.
SCAN HLD Scan Hold. For selecting the amount of time the radio
remains on a particular channel, after a link, during the
scan cycle.
VDET SEL Voice Detect Select. If set to on, detects voice
communication of channels that are scanned and stops at
those channels once voice communications are detected.
VDET HLD Voice Detect Hold. When voice detect is enabled, the
radio automatically stops scanning on channels when
voice communications are detected. For setting the
amount of time the radio remains at that channel, without
hearing more voice communications.
To Next Page
Loading...
