4: Radio Programming
4-24 PRC1099A-MSOP
1. Toggle the TUNE knob down until FORMAT is displayed. Press WHIP TUNE
to make the selection.
2. Toggle the TUNE knob to scroll to the number of the Other address as it is
stored in the ALE menu.
3. Press WHIP TUNE to make the selection.
4. Toggle the TUNE knob to scroll to the From number of the Self Address.
5. Press WHIP TUNE to make the selection.
6. Toggle the TUNE knob to select a message to send. An asterisk * next to the
message number indicates a message is stored with it. To send no mes-
sage, select NONE. (Messages are composed and stored from the
TX MSG selection of the MSG menu.)
7. Press WHIP TUNE to enter the message and initiate the call. The display
indicates CALL and the channel on which the call is initiated. The radio
can be programmed to make from 2 to 6 call attempts (from the
CALL LMT selection in the ALE menu).
If the call is successful, LINK is displayed.
8. To break the link, press WHIP TUNE. The radio returns to the Scan mode or
the channel on which the call was initiated.
All Call To quickly broadcast a message to all stations within an established net without
a response from the distant stations:
1. Exit the Scan mode and access the CALL menu.
2. Select the channel on which the call is to be transmitted.
3. Toggle the TUNE knob down until ALL CALL is displayed.
4. Press WHIP TUNE to make the selection.
5. Display the message to send or select NONE.
6. Press
WHIP TUNE to make the selection and initiate the call. The display
indicates
CALL and the channel on which the call is initiated.
Net Call To make a call to a select group of users defined by a net Other Address:
1. Exit the Scan Mode and access the CALL menu.
2. Press the
TUNE knob down until NET CALL is displayed and press WHIP
T
UNE to make the selection.
3. Press the
TUNE knob to scroll to the desired net other address.
4. Press WHIP TUNE to make the selection and select a message to send. If a
message is not being sent, select NONE.
To Next Page
Loading...
