Davolink DV-332 - Page 71

DV-332 Analog/Digital User Guide
71
===========================================================================
GW/CONFIG/REROUTE>
In order to enable backup(=reroute) feature as you can see above, you need to turn the reroute
mode “ON” first. Default value is "OFF".
GW/CONFIG/REROUTE> mode on©
Apply Success...
GW/CONFIG/REROUTE> mode©
usage : mode on|off
current mode is on
GW/CONFIG/REROUTE>
GW supports up to 3 tables to perform backup(=reroute) processes so that users can have different
approaches and methods to 4 conditions each. This is the basic reroute configuration to PSTN lines:
GW/CONFIG/REROUTE> 1st© /* This can configure the first backup table. */
mode [(1)st|(2)nd|(L)oop|(P)eerIP|(N)ull] : l© /* This option verifies routing table and choose the
route. */
prefix [null|string] : **11© /* It adds this prefix number before checking route table. */
<bit flags of condition in hex>
0x00000001 : LAN Link Down
0x00000002 : Server not connected
0x00000004 : Call Timeout
0x00000008 : Unallocated number
condition : 3© /* Backup will work if there's any LAN link down or server
disconnection. */
play [ivr | beep | none] : beep© /* This option selects which kind of distinguishable sounds GW
generate when backup is working. */
GW/CONFIG/REROUTE> show
===========================================================================
REROUTE Configurations Show
===========================================================================
mode(mode) : on
---------------------------------------------------------------------------
****1st. reroute****
type : IPLoop
prefix : **11
condition : 0x3
0x00000001 : LAN Link Down [ON]
0x00000002 : Server not connected [ON]
0x00000004 : Call Timeout [OFF]
0x00000008 : Unallocated number [OFF]
beep : on
peer ip : 0.0.0.0