DV-332 Analog/Digital User Guide
72
---------------------------------------------------------------------------
****2nd. reroute****
type : NULL
prefix : NULL
condition : 0x0
0x00000001 : LAN Link Down [OFF]
0x00000002 : Server not connected [OFF]
0x00000004 : Call Timeout [OFF]
0x00000008 : Unallocated number [OFF]
beep : OFF
peer ip : 0.0.0.0
---------------------------------------------------------------------------
****3rd. reroute****
type : NULL
prefix : NULL
condition : 0x0
0x00000001 : LAN Link Down [OFF]
0x00000002 : Server not connected [OFF]
0x00000004 : Call Timeout [OFF]
0x00000008 : Unallocated number [OFF]
beep : OFF
peer ip : 0.0.0.0
===========================================================================
GW/CONFIG/REROUTE>
And if you just want to use the first backup table, please choose the following option:
GW/CONFIG/REROUTE> 1st©
mode [(1)st|(2)nd|(L)oop|(P)eerIP|(N)ull] : l©
/* If you choose "Loop" mode, GW will look up the routing table again and find the calling number
when erorrs you will specify in the following conditions occur. Of course, it will add the prefix value
(which you'll add in the following option) before the calling number to distinguish. */
prefix [null|string] : **11©
/* When errors occur, GW will add "**11" digits before the calling number. This prefix can be
changed. Since it is associated with routing table, remind that you should configure a routing table
properly to handle calling number patterns start with prefix. */
<bit flags of condition in hex>
0x00000001 : LAN Link Down
0x00000002 : Server not connected
0x00000004 : Call Timeout
0x00000008 : Unallocated number
To Next Page
Loading...