Decatur Electronics G3 - Quick Start Guide; Initial G3 Setup Instructions

G3
™
User’s & Installation Manual
7/October/2020
11
1.0 Quick Start
Use the following instructions to quick start your G3™:
• Withallcablesandantennasattached,plugthecigarplugofthe
radar into a powered 12VDC cigarette lighter receptacle in the
patrol motor vehicle.
• PressthePWRbuttononthefrontdisplaytopoweruptheradar
unit. The radar will run through a brief self-test which includes
illuminating all display segments.
• PresstheFRONTorREARbuttontoselecttheantennafrom
which you want the radar to transmit. Press the same button
when you wish to place the radar back into standby mode.
• PressandreleasetheMODEbuttontoquicklytogglebetween
Moving Mode Opposite Direction and Moving Mode Same
Direction. Press and hold the MODE button for two seconds to
activate Stationary Mode.
• PressandholdtheFASTbuttontoselectFasterModewhenyou
want to track the faster motor vehicles.
• InMovingModeSameDirectionsetting,G3™willautomatically
perform addition or subtraction relative to the patrol speed to
properly calculate the target speeds.
• Tolockatargetspeed,presstheLOCKbutton(shownasa
padlock on the hand remote). The target speed and its direction
information will transfer to the LOCKED window and locked
direction indicators. The radar will continue to process speeds
and display them in the TARGET window.
• Toclearalockedspeed,presstheLOCKbuttonwhenanantenna
is transmitting, and no target is present.