G3
™
User’s & Installation Manual
7/October/2020
20
After you have mounted the antenna, plug one cable end into the
antenna and the other end into the antenna receptacle on the
computer/display unit.
If you are using only one antenna, you must connect it to the FRONT
antenna receptacle.
2.4 Installation Check
After you install the components, for safety, double-check to ensure
all components are secure. Then check for potential interference from
sources such as the air conditioner/heater fan.
1. With all other motor vehicle accessories o, turn on the heater/air
conditioner fan.
2. Power up the radar by pressing the PWR button on the front
display and select the front antenna by pressing the FRONT
button.
3. Cycle through the fan’s low to high settings.
4. If the unit displays a reading, reposition the antenna to eliminate
it. Often, the far-left corner of the front windshield is an
interference-free zone where you can place an antenna.
5. Repeat this process for the rear antenna.
To Next Page
Loading...