Decatur Electronics G3 - Connecting Separated Units

G3
™
User’s & Installation Manual
7/October/2020
13
Pull the display from the computer and note the 9-pin connectors on
each half of the unit. Screw two standos (included with the display
separation kit) into the holes next to each connector on the display
unit. These standos are used to attach the two pieces with the
9-pin connector cable.
Figure 2.1c
To connect the separated unit, rst insert the
standos to secure the cable connectors.
Then attach and secure the connectors with the thumbscrews on the
sides of each cable connector.
Figure 2.1d
Secure the connecting cable by tightening the
thumbscrews into the standos.
To return the unit to a one-piece conguration, remove the cables
and standos, line up the 9-pin connectors, push the two pieces
together and secure with the two retaining screws.