Genesis II Select
™
User’s & Installation Manual
16/September/2015
30
MENU FEATURE (TEST/OPTN): The menu feature allows the
operator to ne tune some of the settings of the radar. To activate the
menu feature, press and hold the TEST button down until "MENU"
is displayed in the mode window. Pressing OPTN steps through
the menu items and the antenna
buttons change the settings.
Pressing the TEST button again exits the menu feature and saves the
settings.
Feature Setting Function
LOSP 4, 25 (km/h) Low Speed - Minimum speed that the
radar will process in stationary mode.
Default is 25 km/h.
BEEP ON, OFF Beep - Beeps when button is pushed on
the hand remote. Default is ON.
UNTS KPH Display units - Measure speeds in km/h.
COMX 0 through 5 Serial Port Communication Protocol -
Selects protocol for interfacing to MDT,
signs, etc.
0 - no output
1 - Decatur format
2, 3, 4, 5 - Reserved (no output)
Default is 1.
FSTL ON, OFF Fast Lock - Allows the locking of a target
if FAST mode is active. Default is ON.
HAR ON Harmonic Indicator. "H" is displayed in
the target window. when a harmonic
condition exists.
Default is ON.
SDSS 4, 8, 12 (km/h) Same Directions Separation Speed -
Sets the minimum separation speed that
the radar will process in Same Direction
mode. Default is 4 km/h.
To Next Page
Loading...
