Need help?Do you have a question about the DECKEL SO and is the answer not in the manual?
General servicing and lubrication for the index head bracket and swivel arm.
Procedure for removing and cleaning the collet sleeve bearing.
Cleaning and lubricating the index head slide and cross slide surfaces.
Instructions for removing and cleaning the swivel arm.
How to adjust the clamping mechanism for the index drum T4.
Correcting swivel range adjustment using eccentric stop pins.
Description of the seven basic profiles for single-lip milling cutters.
Explanation of essential tool angles for single-lip cutters.
Guidance on recommended cutting speeds for single-lip cutters.
Steps to prepare the machine for centering the cutter lip.
Detailed procedure for accurately centering the cutter lip by grinding.
Steps to set up for grinding side cutting edges.
Procedure for performing circular grinding of cutters.
How to grind the back rake angle for side cutting edges.
Steps to prepare for grinding straight end cutting edges.
Procedure for grinding the back rake angle of straight end cutting edges.
Steps to prepare for grinding rounded end cutting edges.
How to grind the back rake angle for rounded end cutting edges.
Steps to set up the machine for grinding pointed cutters.
Procedure for grinding the back rake angle of pointed cutters.
Steps to set up for circular grinding of tapered cutters.
Procedure for circular grinding of tapered cutters, including profiles.
Steps for grinding the side cutting edge of straight tapered cutters.
Steps for grinding the end cutting edge of straight tapered cutters.
Steps to set up for grinding rounded tapered cutters.
How to grind the back rake angle for rounded tapered cutters.
Procedure for changing the drive cord and grinding wheel.
Description of the welded all-steel pedestal for the grinder.
Steps to install the machine lamp onto the pedestal.
Description of the special index head and its features.
How to use the locating fixture for cutter spindle assembly.
Procedure for exchanging index heads and calculating eccentricity.
Steps to set up the twist drill grinding attachment.
Procedure for grinding twist drills using the attachment.
To Next Page
General