Deif AGC 150 - The Jump Function; Engine Drive Shortcut Menu

4.10 The Jump function
If you know the menu number for a parameter, you can use the Jump function to go directly to the parameter without navigating
through the menus.
On the controller, press the Shortcut
button to activate the Jump menu.
Select Jump to parameter with the Up and Down buttons, activate with the OK button.
Enter the menu number and select with the OK button.
To activate the Jump function in the Utility Software, select the Parameter page and then the Jump menu.
4.11 Engine Drive shortcut menu
The AGC 150 has a shortcut menu for configuring the PID set points. To activate the Engine Drive shortcut menu, press the Shortcut
button.
BLOCKED FOR START
Select with the Up and Down buttons, and select the menu with the OK button.
OPERATOR's MANUAL 4189341186E EN Page 33 of 38