Single genset controller in parallel without mains breaker
4
3
3
5
6
7
8
9
15 14 11 12
1
17
16
2 3 3
18
1013
1. Power ON
2. Display screen (monochrome)
3. Navigation
4. OK
5. Back
6. AUTO mode
7. Silence horn
8. Short cut menu for commands
9. SEMI-AUTO mode
10. Mains symbol
11. Close breaker
12. Open breaker
13. Breaker symbols
14. Generator
15. Engine
16. Stop
17. Start
18. Load symbol
2.2.6 Mimic function
With the Mimic function the operator can choose how the control buttons and LED's are shown on AGC 150, and thereby get a
better overview of the controller in different applications.
Configure the Mimic function under Settings > Basic settings > Controller settings > Display > LED mimic.
Parameter no.
Item Range
6082 LED mimic
Standard with genset
Standard
Guided with genset
Guided
Standard
Control buttons and LED's are continuously visible.
If the genset is stopped, the motor/generator symbols are OFF.
Standard with genset
Control buttons and LED's are continuously visible.
If the genset is stopped, the motor/generator symbols are shown in red.
OPERATOR's MANUAL 4189341186E EN Page 12 of 38
To Next Page
Loading...
