5. Alarm handling and log list
5.1 Alarm handling
If the function Alarm Jump is ON, the controller will automatically show the Alarm list on the display screen, when an alarm occurs.
Activate the function under Service View > Display > Alarm Jump.
Table 5.1
Parameters for Alarm jump
Parameter Text Range Default
9157 Alarm Jump
OFF
ON
ON
Access the Alarm list from the display unit
1. From the View menu, press the button.
2. Scroll to the Alarm list with the and buttons.
3. Press the button to select the Alarm list.
4. Press the
button to leave the Alarm list.
The Alarm list contains both acknowledged and unacknowledged alarms that are active (that is, the alarm condition is still present).
Once an alarm is acknowledged and the condition has disappeared, the alarm will no longer be displayed in the Alarm list. If no
alarms are present, the Alarm list will read No alarms.
The display screen can show only one alarm at a time. The number of alarms is shown in the bottom line.
Figure 5.1
Example of an unacknowledged alarm
DG BLOCKED FOR START
Alarm list:
1/2 alarm(s)
To see the other alarms, scroll with the and buttons.
To acknowledge an alarm, select the alarm and press the
button.
OPERATOR's MANUAL 4189341186E EN Page 37 of 38
To Next Page
Loading...
