4.13 Remote Display local menu
When the Remote Display is connected to a master controller, all buttons and LEDs on the Remote Display is a mirror of the master.
You can change the Remote Display setup from the unit. Press and hold the Shortcut
button until the Remote Display local
menu appears:
Remote unit local menu
Settings
Ethernet setup
Remote display setup
Password
Display
Type
Text Range
Ethernet setup Configure the Ethernet address for the Remote Display.
Remote display setup Configure the Ethernet address for the master controller.
Password
Configure the Password for each password level.
See General product information, Controller overview, Password in the Designer's handbook for
more information about passwords.
Display
Configure light, contrast etc. for the Remote display.
See Controller overview, Overview of buttons and LEDs, Display settings in this document for
more information about display settings.
Type Change type of controller.
Software info Gives you information about the software in the Remote display.
4.14 Exhaust after-treatment (Tier 4 Final/Stage V)
AGC 150 supports Tier 4 Final/Stage V requirements, and provides monitoring and control of the exhaust after-treatment system, as
requested by the standard.
Figure 4.5
AGC 150 Tier 4 Final screen
DEF level: 32.0% 1/20
ISLAND SEMI
OPERATOR's MANUAL 4189341186E EN Page 35 of 38
To Next Page
Loading...
