Delem DAC-360 - Page 57

Delem
V0208, 2.31
The sheet thickness is indicated in the vertical column, as a percentage of the maximum
thickness (parameter 13, ‘Maximum thickness’). For various plate thickness values, the
required gap value can be programmed.
These setpoints can be programmed for each material (column M1-M6).
Parameter 81
Control enable
Range : 0 - 1
Unit : -
Default : 0
Function
Program control for a second gap unit (Gap2) on or off.
0 = No gap control
1 = Gap control
In case of 1, the following I/O is used:
• digital outputs G2+ and G2-
• analog input GFB.
Parameter 82
Prestop positive
Range : 0 - 99
Unit : AD value
Default : 0
Function
The same as parameter 77, but now for Gap 2.
Parameter 83
Prestop negative
Range : 0 - 99
Unit : AD value
Default : 0
Function
The same as parameter 78, but now for Gap 2.
Parameter 84
Gap2 reference table
Range : -
Unit : -
Default : -
Function