page 60
05_Programmazione_en.fm
Machine programming
Bisky
•NUMBER OF TRAYS:
The number you digit will determine how many trays of that recipe you will
produce in automatic mode.
•TRAY EDGE:
The value you digit will determine the distance the tray will advance (distance =
from tray edge to first deposit) before the first row of biscuits is deposited.
• ROW SPACE:
The value you digit will determine the space between each row of biscuits.
• PAUSE BEFORE SUCTION:
The machine pauses before the suction phase starts. This pause duration can be
set.
• DOSING THE FIRST EXTRUSION
This value -expressed in ±%- can be set. It is used to modify the dosing of the first
extrusion of each tray.
• SUCTION PHASE AT THE END OF A TRAY
This value -expressed in %- can be set. It is used to increase the duration of the
suction phase after the last extrusion of each tray.
• CYCLE ACCELERATION
ON/OFF, enables/disables the cycle acceleration function.
Fig. 5.3 Rotary nozzle plate showing nozzle positions for zig-zag biscuit
To Next Page
Loading...