page 66
06_Uso_en.fm
Use
Bisky
Service pages
First page
Press the Service button to access the page shown here below: :
Field 1 allows the type of head to be chosen according to the type of processing to carry
out: "Roller head" or "Pump head" (optional extra)
In field 2 the value for nozzle position reference is set to zero (in the off-centre nozzle type of
processing) so as to allow correct operation by fixing the start point.
In field 3 the rollers can be timed so as to dismantle them during either cleaning or head
changing operations.
In field 4 you can decide whether the tray unloading must be carried out towards the
operator's side or towards the standard side. This function is used at the end of the working
process.
1
2
3
4
To Next Page
Loading...