Figure 12 Installing the front bezel
Verifying successful disk replacement from the ACM
After a disk is replaced, you can run the FRU command line verification from the ACM to ensure
that the replacement was successful.
Procedure
1. Log in to the ACM command line by using SSH.
Use root for the user, and use the common password for the appliance.
2. Type the following command: # showfru disk
acme-dp4400-ACM:~ # showfru disk
Collecting Data............
________________________________________________________________
| ID| State | Status| FW Version| Capacity| Operation| OpStatus|
|===============================================================|
| 0 | Online| OK | NS01 | 10.69TB | None | 0% |
| 1 | Online| OK | NS01 | 10.69TB | None | 0% |
| 2 | Online| OK | NS01 | 10.69TB | None | 0% |
| 3 | Online| OK | NS01 | 10.69TB | None | 0% |
| 4 | Online| OK | NS01 | 10.69TB | None | 0% |
| 5 | Online| OK | NS01 | 10.69TB | Rebuild | 65% | *
| 6 | Online| OK | NS01 | 10.69TB | None | 0% |
| 7 | Online| OK | NS01 | 10.69TB | None | 0% |
| 8 | Online| OK | NS01 | 10.69TB | None | 0% |
| 9 | Online| OK | NS01 | 10.69TB | None | 0% |
| 10| Online| OK | NS01 | 10.69TB | None | 0% |
| 11| Online| OK | NS01 | 10.69TB | None | 0% |
| 12| Online| OK | NS01 | 10.69TB | None | 0% |
| 13| Online| OK | NS01 | 10.69TB | None | 0% |
| 14| Online| OK | NS01 | 10.69TB | None | 0% |
| 15| Online| OK | NS01 | 10.69TB | None | 0% |
| 16| Online| OK | NS01 | 10.69TB | None | 0% |
| 17| Online| OK | NS01 | 10.69TB | None | 0% |
3. Verify the state for all disks is "Online," and that the status for all disks is "OK".
Remove and replace assemblies
26 Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures
To Next Page
Loading...
