Install the system cover
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the guide slots
on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise to the
locked position.
Figure 30 Install the system cover
Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system into the
cabinet. The slam latches will engage to secure the system in the cabinet.
Remove and replace assemblies
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures 45
To Next Page
Loading...
