Remove the NVMe card
Procedure
1. Pull the NVMe card latch.
2. Hold the NVMe card by its edges, and pull the card until it disengages from the expansion
card connector on the riser.
Figure 59 Removing the NVMe card from expansion card riser 2B
Install the NVMe card
Procedure
1. Pull the expansion card latch
2. Hold the card by its edges and align the card connector with the connector on the riser.
3. Insert the card firmly into the connector on the riser until the card is fully seated.
4. Push the expansion card latch.
Figure 60
Installing the NVMe card into expansion card riser 2B
Remove and replace assemblies
76 Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures
To Next Page
Loading...
