Dell EMC DP4400 - Install the Rear Hard Drive Cage

2. Lower the riser into the system until the connector engages with the connector on the
system board.
Figure 46 Installing expansion card riser 2B
3. Pull the expansion card latch
4. Hold the card by its edges and align the card connector with the connector on the riser.
5. Insert the card firmly into the connector on the riser until the card is fully seated.
6. Push the expansion card latch.
Figure 47
Installing the NVMe card into expansion card riser 2B
Install the rear hard drive cage
Procedure
1. Align the screws on the hard drive cage with the screw holes on the system.
2. Lower the hard drive cage into the system until it is firmly seated.
3. Using Phillips #2 screwdriver, tighten the screws to secure the hard drive cage to the
system.
4. Connect all the cables to the rear hard drive backplane.
Remove and replace assemblies
60 Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures