7. Click the X at the right of the Hard disk column to delete the disk from the configuration.
8. Click Save.
9. From the ESXi Navigator, click Storage, and then click DP-appliance-ssd.
10. Click Actions > Delete.
Disconnect the power cords and I/O cables
This procedure is used to disconnect the system from electrical power and disconnect the
peripherals.
Procedure
1. Shut down the system as described in Shut down the IDPA.
2. Label each power cord and I/O cable so you can easily identify them when you need to plug
them in to restore the system.
Remove and replace assemblies
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures 73
To Next Page
Loading...
