Start up the IDPA
You can start the IDPA from the Dell server through iDRAC.
Start up the IDPA from Dell server
About this task
Switch on the power button on the Dell server.
Start up the IDPA from iDRAC
Procedure
1. Turn on the iDRAC and log in to iDRAC from its UI using root user and iDRAC password.
2. Click the Power On System button.
Note: The ACM will be accessible within approximately 20 minutes.
3. Connect to the ACM by accessing the
https://<ACM_IP>:8543
URL from the browser.
Remove and replace assemblies
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures 83
To Next Page
Loading...
