Figure 50 Slide the system into the cabinet
Connect the I/O cables and power cords
This procedure is used to connect the peripherals and power to the system.
Procedure
1. Using the connection information recorded on the labels, connect the I/O cables to the
system.
2. Plug the power cords into the power supplies.
Verifying successful NDC replacement from the ACM
After the network daughter card (NDC) is replaced and power has been re-applied, you can run
the FRU command line verification from the ACM to ensure that the replacement was successful.
Procedure
1. From the ACM, type the following command: # showfru network
The screen displays that the system is collecting data. When the data collection is
completed, the screen displays status information for ports the NIC.
acme-dp4400-ACM:~ # showfru network
Collecting Data............
______________________________________________________________________________
| Name | Port| Link Status| Model Name |
|=============================================================================|
| NIC Integrated 1| 1 | Up | Ethernet 10G 4P X710 SFP+ rNDC |
| NIC Integrated 1| 2 | Up | Ethernet 10G X710 rNDC |
| NIC Integrated 1| 3 | Down | Ethernet 10G X710 rNDC |
| NIC Integrated 1| 4 | Down | Ethernet 10G X710 rNDC |
| NIC Slot 1 | 1 | Down | Ethernet Converged Network Adapter X710|
| NIC Slot 1 | 2 | Down | Ethernet Converged Network Adapter X710|
| NIC Slot 1 | 3 | Down | Ethernet Converged Network Adapter X710|
| NIC Slot 1 | 4 | Down | Ethernet Converged Network Adapter X710|
| NIC Slot 2 | 1 | Up | Gigabit 2P I350-t Adapter |
| NIC Slot 2 | 2 | Down | Gigabit 2P I350-t Adapter |
Remove and replace assemblies
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures 63
To Next Page
Loading...
