Dell EMC DP4400 - Remove the System Cover

2. Using the slam latches, pull the system from the cabinet until the rails lock in the extended
position.
Remove the system cover
Procedure
1. Using a flat or a Phillips head screwdriver, rotate the latch release lock counter clockwise to
the unlocked position.
2. Lift the latch till the system cover slides back and the tabs on the system cover disengage
from the guide slots on the system.
3. Hold the cover on both sides, and lift the cover away from the system.
Figure 32
Remove System cover
Remove and replace assemblies
48 Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures