Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system into the
cabinet. The slam latches will engage to secure the system in the cabinet.
Figure 18 Slide the system into the cabinet
Verifying successful disk replacement from the ACM
After a disk is replaced, you can run the FRU command line verification from the ACM to ensure
that the replacement was successful.
Procedure
1. Log in to the ACM command line by using SSH.
Use root for the user, and use the common password for the appliance.
2. Type the following command: # showfru disk
acme-dp4400-ACM:~ # showfru disk
Collecting Data............
________________________________________________________________
| ID| State | Status| FW Version| Capacity| Operation| OpStatus|
|===============================================================|
| 0 | Online| OK | NS01 | 10.69TB | None | 0% |
| 1 | Online| OK | NS01 | 10.69TB | None | 0% |
| 2 | Online| OK | NS01 | 10.69TB | None | 0% |
| 3 | Online| OK | NS01 | 10.69TB | None | 0% |
| 4 | Online| OK | NS01 | 10.69TB | None | 0% |
| 5 | Online| OK | NS01 | 10.69TB | Rebuild | 65% | *
| 6 | Online| OK | NS01 | 10.69TB | None | 0% |
| 7 | Online| OK | NS01 | 10.69TB | None | 0% |
| 8 | Online| OK | NS01 | 10.69TB | None | 0% |
| 9 | Online| OK | NS01 | 10.69TB | None | 0% |
Remove and replace assemblies
32 Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures
To Next Page
Loading...
