Figure 16 Installing hard drive carrier into mid hard drive tray
Install the system cover
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the guide slots
on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise to the
locked position.
Figure 17
Install the system cover
Remove and replace assemblies
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures 31
To Next Page
Loading...
