Dell EMC PowerEdge MX740c - Removing the Mini Mezzanine Card

Figure 75. Installing the Mezzanine card
Next step
1 Follow the procedure listed in After working inside your sled.
Removing the mini Mezzanine card
Prerequisites
CAUTION
: To ensure proper system cooling, mini Mezzanine blank must be installed in the mini Mezzanine socket.
NOTE: The removal of the blank is recommended only if you intend to install a mini Mezzanine card in this socket.
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside the sled.
NOTE
: MX740c supports HBA330 MMZ and Fiber channel MMZ which is installed in mini Mezzanine slot.
Steps
1 Pull the blue pull tag to raise the lever up of the mini Mezzanine card.
2 Holding the lever and the edge of the mini Mezzanine card, lift the mini Mezzanine card from the system.
102
Installing and removing system components