Figure 76. Removing the mini Mezzanine card
NOTE: Install the connector cap on the I/O connector of the mini Mezzanine card, when not installed on system board.
Next step
1 Follow the procedure listed in After working inside your sled.
Installing the mini Mezzanine card
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside the sled.
NOTE
: The mini Mezzanine card is supported only on systems with two processors.
Steps
1 Remove the connector cap on the I/O connector of the mini Mezzanine card.
2 Pull the blue pull tag to raise the lever on the mini Mezzanine card.
3 Align the mini Mezzanine card connector with the connector on the system board.
4 Lower the mini Mezzanine card into place, and push the lever down to lock the card in place.
Installing and removing system components
103
To Next Page
Loading...
