Figure 15. Installing the sled into enclosure
Next step
1 Power on the sled.
System cover
The system cover protects the components inside the system and helps in maintaining air ow inside the system.
Removing the system cover
Prerequisites
1 Follow the safety guidelines listedin Safety instructions.
2 Power o the sled.
3 Remove the sled from the enclosure.
4 Place the sled on the at surface with the top cover facing upwards.
Steps
1 Press the blue release tab on the system cover and slide the cover towards the rear of the system.
2 Hold the cover on both sides, and lift the cover away from the system.
Installing and removing system components
45
To Next Page
Loading...
