Figure 43. Installing the BBU
3 Connect the BBU cables to the connector on the system board.
Next steps
1 Follow the procedure listed in the After working inside your sled.
2 Replace the drive carrier or a drive blank.
Removing the BBU from the BBU cage
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in the Before working inside your sled.
3 Remove the BBU module.
Steps
1 Using a Phillips #1 screwdriver, loosen the captive screw securing the BBU to the BBU cage.
2 Lift and slide the BBU out of the BBU cage.
66
Installing and removing system components
To Next Page
Loading...
