Dell EMC PowerEdge MX740c - USB Ports; Internal Dual SD Module; Micro SD Vflash Connector; Video Specifications

USB ports
The Dell EMC PowerEdge MX740c system supports:
• One USB 3.0-compliant port on the front of the system
• One micro USB/iDRAC Direct USB 2.0-compliant port on the front of the system
• One USB 3.0-compliant internal port
NOTE: The micro USB 2.0-compliant port on the front of the system can only be used as an iDRAC Direct management port.
Internal Dual SD Module
The Dell EMC PowerEdge MX740c system supports optional Internal Dual SD module (IDSDM) module. In 14th generation of PowerEdge
servers, IDSDM module supports two micro SD cards. Micro SD cards capacities for IDSDM are 16, 32, 64 GB.
NOTE: There are two dip switches on the IDSDM module for write-protection.
NOTE: One IDSDM card slot is dedicated for redundancy.
NOTE: It is recommended to use Dell branded MicroSD cards associated with the IDSDM congured systems.
Micro SD vFlash connector
The Dell EMC PowerEdge MX740c system supports one dedicated micro SD card on iDRAC module for future vFlash support. It is
recommended to use Dell branded MicroSD card associated with the iDRAC module.
Video specications
Table 17. Video
specications
Type Description
Video type Matrox G200 graphics controller integrated with iDRAC
Video memory 4 Gb DDR4 shared with iDRAC application memory
Environmental specications
NOTE
: For additional information about environmental certications, please refer to the Product Environmental Datasheet
located with the Manuals & Documents on Dell.com/poweredgemanuals
Table 18. Temperature specications
Temperature Specications
Storage –40°C to 65°C (–40°F to 149°F)
Continuous operation (for altitude less than 950 m or 3117
ft)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the equipment.
124 Technical specications