Dell EMC PowerEdge MX740c - Removing the M.2 BOSS Module

Figure 69. Installing a MicroSD card
Next steps
1 Install the IDSDM card.
2 Follow the procedure listed in After working inside your sled
M.2 BOSS module
The BOSS card is a simple RAID solution card which supports upto 2 M.2 SATA drives. The BOSS adapter card has a x8 connector using
PCIe gen 2.0 x2 lanes, available only in the low-prole and half-height form factor.
Removing the M.2 BOSS module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your sled.
Step
Holding the blue tag, lift the M.2 BOSS module away from the system.
96
Installing and removing system components