Figure 41. Installing the drive cage
Next steps
1 Install the drive backplane.
2 Install the drives.
3 Follow the procedure listed in After working inside your sled.
Battery backup unit
Removing the battery backup unit
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Follow the procedure listed in Before working inside your sled.
3 Remove the drives.
4 Disconnect the battery backup unit (BBU) cable from the system board.
5 Disconnect the backplane cables.
6 Remove the drive cage.
7 Remove the drive backplane.
Steps
1 Press the latch on the side of the drive cage to release the BBU module.
2 Holding the BBU module by the edges, slide the BBU module out of the system.
64
Installing and removing system components
To Next Page
Loading...
