Dell EMC PowerEdge MX740c - Recommended Tools; Removing the Sled from Enclosure

NOTE: Ability to power on the sled requires iDRAC to fully initialize
rst.
Recommended tools
You need the following tools to perform the removal and installation procedures:
• Phillips #1 and Phillips #2 screwdrivers
• Torx T15 and T30 screwdrivers
• Wrist grounding strap
PowerEdge MX740c sled
The PowerEdge MX740c sled is a server unit that is installed into the PowerEdge MX7000 enclosure.
Removing the sled from enclosure
Prerequisites
1 Follow the safety guidelines listed in Safety Instructions.
2 Power o the sled.
Steps
1 Press the blue release button on the sled to release the sled handle.
2 Holding the sled handle, slide the sled out of the enclosure.
NOTE
: Support the system with both hands while sliding it out of the enclosure.
NOTE: Removing the sled with the enclosure powered on is supported if you shut down the sled before removal.
42 Installing and removing system components