Dell EMC PowerEdge MX740c - Installing the Jumbo PERC Card

Figure 64. Removing the Jumbo PERC card
NOTE: When Jumbo PERC is installed in the mini Mezzanine slot, you cannot install any other controller cards in the
mini Mezzanine slot.
NOTE: The Jumbo PERC card controls the internal drives, and the storage sled drives mapped to the storage controller.
Next step
1 Install the Jumbo PERC card.
Installing the Jumbo PERC card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your sled.
3 Remove the iDRAC card before installing the Jumbo PERC card.
NOTE
: A dual-processor conguration is required to support a Jumbo PERC card.
Steps
1 Remove the connector cap on the I/O connector from the Jumbo PERC card.
2 Pull the blue pull tag to raise the lever on the Jumbo PERC card.
3 Align the Jumbo PERC card with the slots on the system board.
4 Press the Jumbo PERC card until it is fully seated.
5 Close the lever on the Jumbo PERC card.
Installing and removing system components
91