Figure 85. Installing the system board
4 Lower the system board and install the screws to secure the system board to the system.
Next steps
1 Install the following:
a Internal USB key
b iDRAC card
c IDSDM
d Mini Mezzanine card
e Mezzanine card(s)
f PERC card
g Drive cage
h Drive backplane
i Drives
NOTE
: Ensure that you reinstall the drives in their original locations.
j BBU module
k Memory modules
l Processor(s) and heat sink(s)
m Air shroud
2 Remove the plastic I/O connector cover from the back of the system.
3 Install the sled in the enclosure.
Installing and removing system components
113
To Next Page
Loading...
