• Torx #T15 screwdriver
• 5mm hex nut screwdriver
• Plastic scribe
• Wrist grounding strap connected to the ground
• ESD mat
System cover
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet and peripherals.
4 Place the system on a at, stable surface.
NOTE: Ensure that the lock on the side of the system cover is unlocked.
Step
Lift the cover release latch and remove the system cover.
Figure 9. Removing the system cover
Next step
1 Replace the system cover.
Installing and removing system components
41
To Next Page
Loading...
