Figure 51. Removing the system board
Next step
1 Replace or install the system board.
Installing the system board
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
Steps
1 Unpack the new system board assembly.
NOTE
: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identication button while placing the system board into the chassis.
2 Holding the blue holder, incline the system board at an angle and align the connectors on the system board with the slots on the
system, and lower the system board into the system.
3 Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Installing and removing system components
79
To Next Page
Loading...
