Steps
1 Align the optical drive with the optical drive slot on the optical drive cage.
2 Slide the optical drive into the slot until the release tab snaps into place.
Figure 22. Installing the optical drive
Next steps
1 Connect the power cable and the data cable to the optical drive.
NOTE
: Route the cables properly to prevent them from being pinched or crimped.
2 Install the front bezel.
3 Follow the procedure that is listed in After working inside your system.
System memory
System memory guidelines
Your system contains four memory sockets that are organized into two channels. In each channel, the rst socket is marked white and the
second socket black.
52
Installing and removing system components
To Next Page
Loading...
