Installing the optical drive llers
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
3 Remove the front bezel.
NOTE: There are two optical drive llers, plastic ller on the front bezel, and metal ller on the optical drive cage.
Steps
1 On the front bezel, insert the tabs on optical drive blank into the slots and push the blank until it locks into place.
Figure 19. Installing the optical drive ller into the front bezel
2 On the optical drive cage, hold the tabs on the optical drive ller and push the optical drive ller into the optical drive cage.
Figure 20. Installing the optical drive ller into the optical drive cage
Next steps
1 Install the front bezel.
50
Installing and removing system components
To Next Page
Loading...
