Removing the optical drive llers
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
3 Remove the front bezel.
NOTE: There are two optical drive llers, plastic ller on the front bezel, and metal ller on the optical drive cage.
Steps
1 On the front bezel, press the retention clip of the optical drive ller and pull the ller out of the front bezel.
Figure 17. Removing the optical drive ller from the front bezel
2 On the optical drive cage, hold the tabs on the optical drive ller and remove the optical drive ller from the optical drive cage.
Figure 18. Removing the optical drive ller from the optical drive cage
Next step
1 Replace the optical drive ller or install the optical drive.
Installing and removing system components
49
To Next Page
Loading...
