Dell EMC PowerEdge T140 - Removing the Optical Drive; Installing the Optical Drive

2 Follow the procedure that is listed in After working inside your system.
Removing the optical drive
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the front bezel.
4 Disconnect the power and data cables from the back of the optical drive.
NOTE: Ensure that you note the routing of the power and data cable on the side of the system as you remove them from
the system board and drive .
Steps
1 To release the optical drive, press and push the release tab toward the front of the system.
2 Slide the optical drive out of the system.
3 If you are not installing a new optical drive, install the optical drive llers.
Figure 21. Removing the optical drive
Next step
1 Replace the optical drive.
Installing the optical drive
Prerequisites
NOTE
: Only slim 9.5-mm SATA DVD-ROM drive or DVD+/-RW drive can be installed in your system. External optical drives can
be connected through USB ports.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
3 Remove the front bezel.
Installing and removing system components
51