Storage controller card
Removing the integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
3 Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
Steps
1 Press the expansion card retention latch and push down the latch to open it.
2 Hold the expansion card by the edge, and pull the card to disconnect from the system board connector.
Figure 32. Removing the integrated storage controller card
3 If you are not replacing the integrated storage controller card, install a ller bracket.
NOTE
: Installing the ller bracket for integrated storage controller card is similar to installing the ller bracket under,
removing a PCIe expansion card section.
Next step
1 Replace the integrated storage controller card.
Installing an integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure that is listed in Before working inside your system.
Installing and removing system components
63
To Next Page
Loading...
