Dell EMC PowerEdge T140 - Port, Video, and Environmental Specs

Optical drives
The Dell EMC PowerEdge T140 system supports the following optical drives.
Table 18. Supported optical drive type
Supported drive type Supported number of drives
Dedicated SATA DVD-ROM drive or DVD +/-RW drive One
Ports and connectors specications
USB ports specications
Table 19. Dell EMC PowerEdge T140system USB port specications
Front panel Back panel Internal USB
• One USB 3.0-compliant ports
• One micro USB 2.0-compliant port
for iDRAC Direct
NOTE: The micro USB 2.0
compliant port can only be
used as an iDRAC Direct or a
management port.
• Two USB 3.0-compliant ports
• Four USB 2.0-compliant ports
• One internal USB 3.0-compliant port
NIC ports specications
The Dell EMC PowerEdge T140 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports that are located
on the back panel.
Serial connector specications
The Dell EMC PowerEdge T140 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
VGA ports specication
The Dell EMC PowerEdge T140 system supports two 15-pin VGA ports, one each, on the front and back of the system.
NOTE
: The front VGA port is available only with the rack conguration.
Video specications
The Dell EMC PowerEdge T140 system supports Matrox G200eR2 graphics card with 16 MB capacity.
96
Technical specications