Figure 52. Installing the system board
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
NOTE
: The TPM must be replaced only while installing a new system board.
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
b Memory modules
c Processors
d Heat sink modules
e Internal USB key, if installed
f Integrated storage controller card, if installed
g Expansion cards, if installed
2 Replace the iDRAC MAC address label from the system with the new iDRAC MAC address label that came with the replacement
system board.
3 Reconnect all cables to the system board.
NOTE
: Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable securing
bracket.
4 Boot the system.
5 Follow the procedure that is listed in the After working inside your system section.
6 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the system using Easy
Restore.
b If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually. For more information, see
Manually update the Service Tag section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Upgrading the Trusted Platform Module
(TPM)section.
7 Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at Dell.com/poweredgemanuals.
80
Installing and removing system components
To Next Page
Loading...
