Figure 41. Applying thermal grease on top of the processor
3 Place the heat sink onto the processor with the cable end facing the drive carrier.
4 Using the Phillips #2 screwdriver, tighten the screws on the heat sink in the order following:
a Partially tighten the rst screw (approximately 3 turns).
b Tighten the diagonally opposite screw completely.
c Return to the rst screw and tighten it completely.
d Repeat the procedure for the remaining two screws.
NOTE
: The processor and heat sink module retention screws should not be tightened to more than 0.13 kgf-m (1.35 N.m or
12 in-lbf).
Figure 42. Installing the heat sink
Installing and removing system components
71
To Next Page
Loading...
