Dell EMC PowerEdge T640 - Installing a Nvme Drive Bay or Flex Bay

Steps
1 Using the Phillips #2 screwdriver, remove the two screws that secure the NVMe drive bay to the system.
2 Push the release latch down and slide the NVMe drive bay out of the system.
Figure 53. Removing a NVMe drive bay or ex bay
Next step
1 Installing the NVMe drive bay or ex bay.
Installing a NVMe drive bay or ex bay
Prerequisite
NOTE
: The procedure to install the ex bay is identical to installing the NVMe drive bay.
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the tabs on the NVMe drive bay with the slots on the front of the system.
2 Insert the NVMe drive bay into the system until the tabs click into place.
3 Using the Phillips #2 screwdriver secure the NVMe drive bay to the system.
100
Installing and removing system components