Dell EMC PowerEdge T640 - Installing Optional IDSDM or Vflash Module

Figure 83. Removing the optional IDSDM/vFlash module
NOTE
: There are two dip switches on the IDSDM/vFlash module for write-protection.
Next step
1 Install the optional IDSDM/vFlash card.
Installing optional IDSDM or vFlash module
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
2 Align the IDSDM/vFlash card with the connector on the system board.
3 Push the IDSDM/vFlash module until it is rmly seated on the system board.
138
Installing and removing system components