Figure 95. 3.5 inch x18 internal PERC
1
SAS cable (BP: SAS_A0 to internal PERC card: SAS_A) 2 SAS cable (BP: SAS_B0 to internal PERC card: SAS_B)
3 internal PERC card 4 3.5 inch x18 SAS/SATA backplane
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the GPU card holder.
Steps
1 Holding the integrated storage controller card rmly, lift the card out of the server.
2 Disconnect the data cables from the integrated storage controller.
148
Installing and removing system components
To Next Page
Loading...
